The Trackless Electric Infrared Asphalt Heater and Generator has been developed to replace traditional propane asphalt heaters with a completely different design concept. To replace propane an 80 HP generator powers electric elements.

Two Machines in One

When the asphalt heater is not in use it can be separated from the generator frame in less than five minutes by simply pulling four pins. The 80 HP generator produces 45 KW and 175 amp. It has both 110 V and 220 V receptacles. This will power welders, pumping stations, municipal buildings, emergency shelters, etc. The generator comes equipped with safety lockouts and security fencing for the tractor and generator.

No Open Flame

There is no open flame. Electric elements produce an even and controlled heat which will not burn the surface.

Controlled Cycle Times

Cycle times are controlled by a timer. Once you have established the optimum cycle time for the conditions you can use that as your baseline and bump the timer control up or down in two-minute intervals.

Simplicity of Operation

Very little training is required due to the simplicity of operation. The operator lowers the heater, sets the cycle time and hits the cycle start button. Simple, safe and no consumables to worry about.

Eliminate:

• propane tank storage regulations
• training/license for changing propane tanks
• running short of tanks
• possibility of leaking valves or tank ruptures
• open flame in close proximity to propane tanks
• open flame over or near catch basins or man holes where methane gas or other flammable liquids or gases could be present.

Manoeuvrability

Since the heater is mounted in front of the tractor it is easier to manoeuvre than trailer units. With the precise control of the tractor’s articulated steering, the operator can accurately position the infrared heater in areas where it would be too awkward to do so with a trailer unit.

Generator may be purchased separately.